ACTi E66 Przewodnik Instalacji Pobierz pdf (Strona 15)

E-15

• Do not tighten the screws with too much force, since it can damage

the PS-A unit's.

• The torque necessary to create a drip-resistant seal is 0.5 N•m.

• Depending on the installation panel's thickness, etc., the number of installa-

tion fasteners used may need to be increased to provide the desired level of

moisture resistance.

• Be sure to use installation fastener model CA3-ATFALL-01.



Attach the PS-A unit to an Arm

To attach the PS-A unit to an Arm or to the wall, insert the attachment screws for a

commercial-type arm or wall mount adaptor into the holes in the PS-A’s rear face.

(Holes specifications: VESA 75mm)

For detailed attachment instructions, please refer to that product's installation

guide.The VESA Arm Attachment Hole dimensions are signifies as follows;

75[2.95]

(unit: mm[in.])

Rear Face

Attach the four (4) M4 attachment screws. (Screw length : 6mm or less.) The torque

required for these screws is 0.7 to 0.8 N.m.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Brak uwag

ACTi E66 Przewodnik Instalacji Strona 15