ACTi ACM-8201 Instrukcja Użytkownika Pobierz pdf (Strona 11)

1-7

and LED’s. Connected devices can be activated by Output buttons on

the Live View page or by an Event Type. The output will show as

active (in Event Configuration > Port Status) if the alarm device is

activated.

•1 digital input - An alarm input for connecting devices that can toggle

between an open and closed circuit, for example: PIRs, door/window

contacts, glass break detectors, etc. When a signal is received the state

changes and the input becomes active (shown under Event

Configuration > Port Status).

•Auxiliary power and GND

GND Pin 1 Ground Description

Auxiliary

Power

input

(not to

power

this

camera)

Pin 2 Electrically connected in parallel with the con-

nector for the power supply, this pin provides an

auxiliary connector for mains power to the unit.

This pin can also be used to power auxiliary

equipment, with a maximum current of 100mA.

Voltage: 12V DC,

Max: 1.2W

Digital

Input

Pin 3 Connect to GND to activate, or leave floating (or

unconnected) to deactivate.

Must not be exposed to

voltages greater than 30V

DC.

Transistor

Output

Pin 4 Uses an open-collector NPN transistor with the

emitter connected to the GND pin. If used with an

external relay, a diode must be connected in

parallel with the load, for protection against

voltage transients.

Max load = <100mA

Max voltage = 24V DC

(to the transistor)

Be sure to refer to the pin number above the connector before you

connect to external DI/O devices.

Connect input/output devices to the camera as follows:

1. Attach the cables for the device securely to the supplied green

connector block.

2. Once the cables are connected, push the connector block into

the terminal

1 2 ... 6 7 8 9 10 11 12 13 14

Komentarze do niniejszej Instrukcji

Brak uwag

ACTi ACM-8201 Instrukcja Użytkownika Strona 11

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Kamery ochrony ACTi ACM-8201